Installation instructions

This page contains all the instructions you need to install our pleated blinds, insect screens and duo systems correctly.

🔧 General installation instructions

Package contents:
– 1x complete pleated blind / insect screen / duo system
– 2x side guides
– 4x plastic corner pieces
– Fixings (screws included)

Take care when unpacking:
– Open the package carefully. Do not run a sharp blade along the profiles.
– Do not cut or damage the cord.
– Check that the cord is seated properly on the rollers.

Installing the guides:
1. Clip or slide the first guide onto the matching tab on the main profile.
2. Check that the cord is seated correctly on the roller.
3. Snap it into place and repeat on the other side.
4. Then fix the assembly in place using the relevant installation method below.

Choosing a profile:
– For a low threshold, use the shortest corner piece (recognisable by its size).
– For a standard profile, all 4 corner pieces are identical.

Need help?
We’re happy to help with a free video call. Contact us via WhatsApp or call us to arrange an appointment.

---

1. Window / door

• Place the frame inside the opening.
• Fasten the frame with screws through the pre-drilled holes at the 4 corners.
• Cut the guide to size, pre-drill the holes and fix it in place.
• Make sure everything is square and test that the system works.

2. Veranda sun shading

• Install between the veranda beams.
• The guide has 2 layers. Pre-drill only the outer layer (8 mm).
• Do NOT drill through the inner layer, or the screw will pass through it.

3. Sliding glass wall (up to 6 metres)

• Use long self-tapping screws at all 4 corners.
• Raise the top profile by 2 mm and add a screw in the centre.
• Take care at the main profile, where 4 cords pass through eyelets.
• Drill only between the eyelets, where there is no cord.